You’re ignoring this member’s posts.
Buy used equipment to perform REM analysis
This topic is closed.
8 replies892 viewsLast reply
Quite a bit of stuff on eBay, but you need to take your time to know the brands/models and the required accessories. Plus over time the prices vary a lot. Let us know how your journey goes.
You’re ignoring this member’s posts.
I think an even greater challenge than finding the equipment and learning how to use it properly is how you’re going to get it calibrated.
You’re ignoring this member’s posts.
Some of the older equipment may not have the ability to change the signal for measurement. Some of the signals available are better and more accurate than others.
You’re ignoring this member’s posts.
Not sure what your use-case is, but for personal use I decided to pay to have done and then I saved (restored actually) the result in the software. I use that as my baseline for self-programming
You’re ignoring this member’s posts.
Thanks for your advice. I have been looking at ebay and there are several for sale there. Also, before I purchased one I would seek thoughts about the particular unit from the forum.
You’re ignoring this member’s posts.
You’re ignoring this member’s posts.
You’re ignoring this member’s posts.
Your solution is the exact one I hope I can find and how I would like to fine tune my . I will pursue this when my remote fitter has finished adjusting them. Thanks for your help.
You’re ignoring this member’s posts.
Related discussions
Hearing Aids15 replies
Hearing Aids15 replies
Hearing Aid Self-Fitting (DIY)6 replies
Fitting Software Requests1.1k replies
Uncategorized451 replies