Roger Select Battery Replacement

Do I really need to solder/unsolder or can use the plugin that is already existing with the battery wires? I have never done anything with soldering.

If the plug is the same, then you can just connect it.
But I have not seen any with the correct plug.
Post a picture of the new plug.

I found this:

You will have to change the Plug … cut and splice the wires if you would rather

Will I still need soldering? What is inside the roger, can I plug in the wires or have to solder them?

I think it’s similar to opening a mobile, you need these tools that mobile technicians use. My opinion, not sure. Something like this, maybe?

use a pin or some other small tool to remove the rubber plus over the screws… then a T4 to remove the 3 screws … then I use my thumb nail to smap the two part apart .

Where can you see the screws? There are no screws on the outer surfaces

@GrayGhost Thank you

But how do you open it?

After you remove the 6 screws … work you fingernail between the top and bottom and slid it along and around the bottom end and it will come apart

I really struggle to see 1, let alone 6 screws. There are 3 rubber covers, is that where the screws are?