Skip to content
HearingTracker
Log in

Adjusting default volume

This topic is closed.

7 replies1.1k viewsLast reply

Link to this topic

I’m rather new to self fitting and so learning to crawl before I walk. I am using Phonak Target ver 9 on my Phonak Marvel 70s.

I wish to adjust only one sub-program within Autosense 3.0 and that is Speech in Noise. I understand how to incr/decr noise block, wind block etc for this one sub-program but what about increasing or decreasing default volume?

Is it a matter of clicking the ALL box on the grid that shows and G50, G65 and G80 and then click the arrow up or arrow down to increase/decrease volume? Does this action increase anything the microphone picks up, meaning background noise as well as speech?

My objective is to reduce background noise in a big box/grocery store so that I can hear a clerk on the sales floor or the clerk at checkout.

My has been measured as 12, so my understanding is speech has to be 12 db higher than background noise.

TIA

5 people in this conversation2 min readJump to latest
@orgullodemexico said:

clicking the ALL box on the grid that shows MPO and G50, G65 and G80 and then click the arrow up or arrow down to increase/decrease volume?

Yes

@orgullodemexico said:

Does this action increase anything the microphone picks up, meaning background noise as well as speech?

Yes although you could try G65 only but the other lines will also increase anyway.

@orgullodemexico said:

speech has to be 12 db higher than background noise.

Don’t think any is capable of this. Not even the Phonak Roger.

Have you tried the automatic self adjustments, where you click what matches you, like traffic too loud, or too soft?

Edited

In reply to @orgullodemexico

is Maximum Power Out , and this setting limiting the maximum power for each chanel

to decrease volume you can mark all G50, G65 and G80 and click down arrow to reduce the overall volume. You can rise just G65 (and G50) for speech

Als Zebras stated , you can try the Automatic Fine Tuning in Target , to get information and tips for the issues you are trying to solve.

Phonak Target Self Programming Adjustments
I’m assuming you don’t have access to REM equipment. -Plug in your audiogram -Pick a fitting rule (Adaptive Phonak Digital? Why not - for a start anyway) -Generate an initial fit -Play around –use the audio samples in Target for starters –the “automatic fine tuning” is pretty good for addressing specific issues (and it will also show you what parameters are important for each issue) –go out in the world and try it out –come back and mess around some more Check out audiologyonline.com. P…

You also can try to increase the MPO that will change (lower) the compression for each channel. If you decrease the MPO the compression will rise (go up).

In reply to @orgullodemexico

You shouldn’t be making any attempt in adjustments to when your not sure what your doing! Look at it as a “safety valve” to your hearing, your pushing 70-80dB in some frequencies, also another annoying thing called “clipping” I’d just leave it set by Target.

Good morning,
For the Quicksin, I rather use the (aided or unaided) speech test results as a cross check tool. I will not adjust the hearing aid as per the speech test results. If the Quicksin measurement is 12, the should be moderate, which is compatible with your .
My advice is don’t be too ambitious when self-fitting. Maybe try 3 steps first. Don’t add 12dB which may be too loud.
Have a great day.

Related discussions