Skip to content
HearingTracker
Log in

How do I configure the MPO in Signia Connexx?

This topic is closed.

11 replies283 viewsLast reply

Link to this topic

I am trying to adjust the in the Sound & Loudness section under Fine Tuning, but it’s confusing in the Connexx software. It’s not like Phonak Target, where I can work with numbers. Any idea how this works?

Signia Connexx

image

Phonak Target

image

3 people in this conversation2 min readJump to latest
@Deadman42 said:

Any idea how this works?

Works pretty much the same, you shouldn’t be adjusting in most cases, at the top of the handle graph, as you adjust the sliders you’ll notice them change, right click and hold move your cursor up or down.

I suppose the issue I am having is that I cannot adjust any further, unlike with Phonak Target. I am not sure what is limiting it in Connexx. The is 58 in Phonak Target, but the slider for Connexx won’t let me go any further. These settings were provided by the audiologist at the time I had my hearing test and were used to fit me with the hearing aids.

Looking at the graph and the sliders, it seems that when the sliders are at the top, the receivers have reached their maximum capacity. The only area where it can be increased (based on my interpretation of the graph) is between 500 and 5K.
Do your Phonaks and Signias have the same power output (hardware)?

The Phonak’s have a 1S Receiver, Signia 2S Receiver, and Jabra 1M Receiver. If that is what you mean.

In reply to @Deadman42

@Deadman42 said:

I suppose the issue I am having is that I cannot adjust any further, unlike with Phonak Target.

There’s set limits based on your audogram and the receiver used, you can not compare with target, each manufacturer is slightly different, you most certainly won’t get the exact same results obviously from different software, you’ll need to go to medium power receiver or change the formula, easy enough.

I am not playing with them; these were already configured by my audiologist. All I am doing is matching it. The fitting program that is being used is . I just like having the same measurements, I guess, probably cause of my ocd.

SmartFit:

image

In reply to @tenkan

Yep, I think that is the issue, it’s using a 2S Receiver which is capping the gains and mpo. With the 1M or 1S receivers, I can replicate the gains and mpo in SmartFit and Phonak Target, but can’t in Signia Connexx. I appreciate the help.

Related discussions