Skip to content
HearingTracker
Log in

Resound Omnia vs Phonak Lumity

This topic is closed.

644 replies38.9k viewsLast reply

Jump
Link to this topic

The region right around Wortley Village was quite nice. Also, some of the parks along the Thames River. I wouldn’t mind living in some of the houses down near where Wortley intercepts Commissioners. Real estate prices are out of sight, though. The Wortley Village area reminded me of some of the suburbs of Pittsburgh, like Squirrel Hill. Pittsburgh has some really tough, nasty areas but there are still great places to live there, as I’m sure there are in most American and Canadian cities.

In reply to @JordanK

Jordan, just wanted to give you some info. … my active vent rec. wires finally came in and while my audi was changing them onto my ’s I mentioned that you said that your hearing loss wasn’t suitable for the AV’s … he said that was only if your loss was flat straight across down around 100 … I showed him your from my phone and he said that you were suitable to try them

Zebra, he never said that it would be optimal… he said that that he could still try them… I know I’ve worn both and the AV wires are amazingly better

@Louie, a provider, made a comment earlier in this thread that ActiveVents are expensive and need to be changed every six months. Perhaps Louie, another provider, or someone who has used them for a while could actually comment on the likely average yearly cost of using them.

Resound Omnia vs Phonak Lumity
Hey Jordan. Activent receivers would be pointless and expensive for you. They are designed for people who have normal or mild hearing loss in the low frequencies, and would therefore be fit with an open dome. If your activent opened up, you’d lose all the low-end amplification that you require. Activents need to be changed every 6 months and they are $$$.

A related question. Can one set the opening size of the ActiveVent as one desired or get them with different open bore sizes?

@jim_lewis said:

Can one set the opening size of the ActiveVent as one desired or get them with different open bore sizes?

There is no adjustment to the size of the opening.

The pictures in the linked web page below show the openings around the outside of the receiver, looks like cheese grater screen that the sound comes into and through the middle of the receiver.

Special Features of Phonak Hearing Aids – The Active Vent26

WH

In reply to @Ureout

I believe the person at Phonak said I wasn’t a good candidate for Activent because I am already wearing heavy double domes so I’m getting the benefit of a somewhat closed fitting. In the open position, Activent would be too open for my loss and there would be too much leakage at the low end. She felt Activent is for people with mild low frequency loss but who struggle in the speech frequency range.

Does this make sense?

Jordan.

I just read the info and watched the Dr Cliff video on the AV rec. wires … great info and I didn’t know that they should be replaced every 6 months … that in itself could be a deal breaked for many… anyone have any idea how much AV wires are??

i have a question… while trialing the Lumity’s and using the phonak TV streamer if I get a text on my Iphone and open up my phone to read the text and then close my phone back off many times I lose the TV Connector + Mic stream and ’s revert back to Automatic program… Is there a way to stop this without just leaving my Iphone on??

When the Lumity hearing aids are connected to the TV Connector, it is a direct connection and the hearing aids are definitely not routing through the phone. If you receive a text on your phone and you have it setup so that you hear audio alerts via the hearing aids, this alert sound may be temporarily grabbing the audio connection away from the TV Connector so that you can hear the text message alert sound. It should automatically revert back to the TV Connector after a few seconds. If it does’t you may have more than three bluetooth devices on at the same time and it is reconnecting to something else. I am very careful to never leave more than two bluetooth devices on at once and I have had zero issues with bluetooth and Lumity. I suspect this is what causes most of the complaints about bluetooth.

What I do is flip the little switch on the side of my iPhone to mute system sounds and this prevents system sounds from interrupting calls, TV watching, etc.

Jordan

Jordan, thx… I know for sure that I never have more than 2 hooked at once… I also should have said that if i;m streaming TV and I just want to open my iphone and say check my e-mail, or sport scores on a sports app that this also will interupt the stream and yes as you said it sometimes does revert back to the streamer but many times it just goes back to automatic… I have also on occasion lost the connection totally on my iphone and have to get up and press the button on rear of TV streamer to start it up again

@Ureout said:

I just want to open my iphone and say check my e-mail, or sport scores on a sports app that this also will interupt the stream

Turn off your phone’s system sounds.

In reply to @JordanK

Thank you Jordan. I’m waiting to order up Lumity 90s. I appreciate your review snd I found it very helpful. Been following your posts. I presently have Paradise 90s and like them, but thinking Lumity will be an improvement with speech.

@Sequoia_Woman said:

I presently have Paradise 90s and like them, but thinking Lumity will be an improvement with speech

I’m not so sure, pretty much the same , but with a different name, autosence was updated… the “waterproof” turned out to be a poor joke, save your dollars until they offer a real update, like new chip/processor, etc.

Edited

In reply to @tenkan

@tenkan said:

I’m not so sure, pretty much the same HAs, but with a different name, autosence was updated… the “waterproof” turned out to be a poor joke, save your dollars until they offer a real update, like new chip/processor, LE Audio etc.

Not so sure I agree with you. Yes…in the past, processors and other platform hardware upgrades provided a major upgrade in sound quality. I think the processors in the latest generation of Phonak hearing aids have reached a point where they are lightening fast and most of the big changes will now come from software upgrades. Basically you don’t have to wait for a hardware upgrade to see improvements in speech and sound clarity.

Also…don’t underestimate Phonak’s Autosense 5.0 upgrade in Lumity. Autosense 5.0 is just one of a number of software enhancements that Phonak has added to Lumity as part of their Smartspeech update. Also included is Speech Enhancer and StereoZoom 2.0. All of these software changes are very significant and have provided me with an enormous improvement in speech understanding across a wide variety of listening environments. The biggest thing I have noticed is how fast and smoothly Lumity reacts to changing sound environments. IMHO, it’s a game changer and not other hearing aids that I have tried respond like this.

I think @Sequoia_Woman should try out the Lumity Platform and see if it provides her with a significant upgrade over the Paradise hearing aids. I’m actually looking forward to hearing her comments after she has had a chance to compare the two.

Just my 2 cents…

Jordan

In reply to @JordanK

Yeah sure, its always a good idea to trial your next potential , however in this case I don’t think there’s going to be a significant difference, software is always good,but only as good as the hardware, I think Phonak skimped out on the Lumity, the next platform will be the one to watch.

@tenkan: Just curious. Have you tried the new Lumity hearing aids? Not sure how you can come to the conclusion that the new software enhancements are trivial without testing them yourself.

Jordan

I have a question… i’m trialing the lumity’s with MAV 3 receiver wires, I’m thinking of asking my audi for a set of the old style M3 wires so I can interchange them to see the hearing differences… can I use the same set-up on my Automatic program for both sets of wires??

Related discussions