Skip to content
HearingTracker
Log in

iCube II connection

This topic is closed.

19 replies1.2k viewsLast reply

Link to this topic
Edited

I just got this device and it won’t connect by USB cable, I found a Bluetooth adapter and target finds the device but says firmware needs to be updated before it can be used. well it will only update via USB cable that it won’t connect . I have tried other cable and did not help.

Any help appreciated.

4 people in this conversation3 min readJump to latest

When you are in Target and go to updates. Select the iCube. Target should tell you to connect to it using the USB connection.
Are you doing this?

In reply to @tenkan

@tenkan said:

You need to go to setup in target and click on fitting device, and then click on icube, then enable icube for fitting, you then need to use the pairing assistant and pair icube by usb cable, this should do it.

I don’t see pairing assistant just paring for icube11 adapter and one for third party adapter.

The first page when you load Target. Across the bottom are selectable icons. One of them is set up. Go there and find fitting devices. Select your iCube.

In reply to @tenkan

@tenkan said:

You need to go to setup in target and click on fitting device, and then click on icube, then enable icube for fitting, you then need to use the pairing assistant and pair icube by usb cable, this should do it.

Oh I see what pairing assistant is.

Edited

Hello. Greetings and a hug to all, I am learning a lot with you and delighted with all the wisdom that is shared in the USA. In Spain this whole world is dark and mysterious.
I have the same problem with the ICUBE II.
I have gone through all the steps and the icube ii does not work because the firmware is old. Tried it to update to version 5.4 and it doesn’t support such old firmware either. Can’t be updated in any way? I’m going to return it to ebay… my beginnings in are being a bit frustrating… still haven’t been able to connect my phonak audeo v70. Soon I will have some Lumity with noah wireless, I hope I won’t have a problem…

Hello: My audis are phonak audeo V70 312 . The software is target 8.1.2 and I also tried on version 5.4.2 . At no time did it let me update the icubeII because it had an outdated firmware. Thanks!

When you plug the Icube II into your computer, does your computer recognize it?
Thanks

Do you think I will have firmware problems with Hipro and target 8.1? Hipro, not Hipro2. I need to configure audeo V70 312. I hope it’s a better option via cable with Hipro. Today I returned the IcubeII, there was no way to update that firmware that it had.

@user700 said:

Today I returned the IcubeII, there was no way to update that firmware that it had

Very strange indeed, I’ve had quite a few of these over the years without any firmware issues, but there’s always a first!

@user700 said:

Do you think I will have firmware problems with Hipro and target 8.1? Hipro, not Hipro2.

No you shouldn’t have “firmware” at all, I can’t recommend HiPro over the iCube ll, but if your happy to use cables then go for it.
You don’t need or want target 8.1 for those old V70’s, you could just use 6 or 5.
Just be sure to get the right cables CS44a for Phonak.

Edited

thank you very much for your help. I understand that icubeII system is better. I’ll try to find one with the updated firmware and try. :grinning:

I’ll have a look at mine, I still have a couple laying around and will check to see what firmware is on them.

Related discussions